Core SWX HypercineV4 392Wh V-Mount Battery Pack and Charger

Core SWX has transformed its award winning Hypercore series of battery packs into a block battery form factor with this Core SWX HypercineV4 392Wh V-Mount Battery Pack and Charger. The Hypercine supports the film and digital cinema markets by offering both 14.4v and 28v power outputs. With a 28V output you can power LED and HMI lights.

The Hypercine was developed based on requests for an air travel friendly, Li-Ion, block battery solution. Leveraging their high-draw Hypercore battery technology, Switronix has been able to provide a device which allows the user to place four brick battery packs within the device housing, transforming it into one single unit, while also offering simultaneous, built-in charging. With four Hypercore 98 batteries installed, the unit provides 392wh. Keeping travel guidelines in mind, you may also use Hypercore Prime battery packs, increasing the maximum capacity to 760wh. Each battery pack is placed within a hopper style system, with locking panels, allowing you to transport the unit just as you would a block battery.

With the battery packs installed, you can choose to use the dual 14.4v 4-pin XLR outputs, or simultaneously use the 14.4v outputs with the 28v 3-pin XLR output. When you're done using the battery pack, supply the Hypercine with 100-240VAC via it's AC in, and charge up the unit in as little as 3 hours. A large, multifunction backlit LCD is present on the front of the unit to provide cumulative data when in discharge modes, and isolated battery pack information when in charge mode.

A built-in 28v regulator insures that the proper power is provided, while incorporated low-voltage circuitry insures the battery packs within are well protected. The Hypercine is a travel friendly, light weight, modular system, powerful enough to provide extended runtime to cameras including ARRI, Sony F65, RED, Panavision, etc. The 28v output can also be used to power HMI, and heavy draw LED lights. Hypercine will ONLY work with SMART battery packs and the four packs must be of equal capacity.

A built-in 28v regulator insures that the proper power is provided, while incorporated low-voltage circuitry insures the battery packs within are well protected. The Hypercine is a travel friendly, light weight, modular system, powerful enough to provide extended runtime to cameras including ARRI, Sony F65, RED, Panavision, etc. The 28v output can also be used to power HMI, and heavy draw LED lights.

Hypercine will ONLY work with SMART battery packs and the four packs must be of equal capacity.

Power Consumption with Various Cameras*

• ARRI ALEXA: 3.75 hours
• ARRI ALEXA Mini: N/A
• Blackmagic URSA: 7.5 hours
• Blackmagic URSA Mini: N/A
• Phantom Flex: 2.5 hours
• RED DRAGON: 6.5 hours
• RED EPIC/SCARLET: 6.5 hours
• SONY FS7: 20 hours
• SONY F34/35 SRW1: 3.75 hours
• SONY F65/SR-R4: 3.75 hours
• SONY F5/F55: 16 hours

* NOTE: Data pulled from manufacturer's Power Consumption Chart.