Gen Energy Mobile Power Distributor Battery Bundle for ARRI SkyPanel Series (S30, S60, S120)

The Gen Energy Mobile Power Distributor Battery Bundle for ARRI SkyPanel Series (S30, S60, S120) includes the compact, lightweight Mobile Power Distributor, featuring Gen Energy’s advanced PCB, firmware and chipset, and (2) G-B100/290W 22A batteries (standard 14.4V), which can supply up to 48V, 10A combined output.

NOTE: Fixtures and other accessories sold separately.

Distributor Features & Specifications:

• Connector: 3-pin XLR
• Power: 48V DC output, 10A regulated
• Batteries: 14.4V 22A (min. 264W) input
• Batteries: G-B100/290W 22A (2 units required)
• Weight: 3.3 lb (1.5 kg) without batteries
• Dimension: 8.54" x 6.09" x 3.62" (217mm x 154.8mm x 92mm)
• Recommended Operating Temperature: 14°F to ~113°F (-10°C to ~45°C)

The shockproof and compact Gen Energy G-B100 290Wh 22A 14.4V Li-ion Battery - V-Mount was designed for use with ALEXA LF and Skypanel S60 as a full power working solution. Features a special algorithm to extend the life time of your battery. There are (2) D-Tap connection ports on the battery, plus a USB port.

This battery charges in approximately 7 hours on the optional GEN ENERGY Portable Battery Charger. Battery run time reduces when it is working below or above the recommended operating temperature. Temperature is lowered with no wires inside.

The Gen Energy V-mount battery is manufactured from Samsung's 3500mA 18650 Lithium-ion battery.

Charging Notes

• Do not use the battery (Main, D-Tap, USB) while charging. If so, it may cause a charging error or damage the charger.
• Charge the battery to full before first use.
• When you charge this battery, Battery capacity LED gauge button will turn on indicating the capacity being charged.
• Lithium-ion batteries have a slight self discharge, therefore it is recommended to charge prior to use.

Discharge Notes

• Do not use the battery (Main, D-Tap, USB) while charging. If so, it may cause a charging error or damage the charger.
• Camera's low voltage alarm is recommended to set 13~13.5V.
• Battery will stop at 12V to extend its life. Microwave transmitters with 5W outputs or over should be kept as far away from the battery. It may disrupt or stop supplying power.
• Be sure to remove the battery from the device after use. If so, it will consume large standby power and over-discharge protection may be activated.
• USB is activated by pushing Battery capacity LED gauge button. USB power will turn on automatically 30 minute after no use.
• Battery run time reduces when it is working below or above the recommended temperature range.